歡迎光臨濟南宏泰食品機械有限公司網站!

全國咨詢熱線
切片機常見的故障有哪些?
發布時間:2022-03-26 來源:http://jonathasdeandrade.com 發布人:admin

凍肉切片機在生活中已是常見的一種食品設備了,在使用中,有時難免會出現一點故障,為了保證良好的使用效果,就要對其充分的了解故障原因,以便我們合理的進行避免和預防。
Frozen meat slicer has been a common food equipment in life. Sometimes there will be some faults in use. In order to ensure good use effect, we should fully understand the causes of the faults, so that we can reasonably avoid and prevent them.
1、機器不運轉:檢查插頭接觸是否良好,再檢查插座保險是否熔斷。仍不能排除故障則需由電氣技術人員檢修。
1. The machine does not work: check whether the plug is in good contact, and then check whether the socket fuse is blown. If the fault cannot be eliminated, it shall be overhauled by electrical technicians.
2、機體帶電:須立即拔掉凍肉切片機電源插頭,檢查接地是否良好,找電氣技術人員處理。
2. Electrified body: Unplug the power plug of frozen meat slicer immediately, check whether the grounding is good, and find electrical technicians to deal with it.


凍肉切片機的常見故障分析
Analysis of common faults of frozen meat slicer
3、切片效果不佳:檢查刀片是否鋒利;檢查凍肉溫度是否在0℃到-7℃范圍;重新磨刀片刃口。
3. Poor slicing effect: check whether the blade is sharp; Check whether the temperature of frozen meat is in the range of 0 ℃ to - 7 ℃; Regrind the blade edge.
4、托盤走動不順暢:走動圓軸加潤滑油,調節走動方軸下方的頂緊螺絲。
4. The tray does not move smoothly: add lubricating oil to the moving round shaft and adjust the jacking screw under the moving square shaft.
5、工作時發出異響:檢查機器螺栓是否松動,檢查機器走動部分潤滑油是否用完,檢查刀片圓周有無碎肉。
5. Abnormal noise during operation: check whether the bolts of the machine are loose, whether the lubricating oil of the moving part of the machine is used up, and whether there is broken meat around the blade.
6、機器震動或有輕微噪聲:檢查工作臺是否穩固,機器放置是否平穩。
6. Machine vibration or slight noise: check whether the workbench is stable and whether the machine is placed stably.
7、砂輪不能正常磨刀:清潔切片機的砂輪。
7. The grinding wheel cannot grind the knife normally: clean the grinding wheel of the slicer.
8、切片工作時,機器無力檢查傳動皮帶是否沾有油污或斷開,檢查電容有無老化現象,檢查刀片刃口是否鋒利。
8. When slicing, the machine is unable to check whether the transmission belt is stained with oil or disconnected, whether the capacitor is aging, and whether the blade edge is sharp.
在使用凍肉切片機時,若遇到以上的故障,應立即停機檢查相關配件,根據故障分析出具體原因,立即,讓切片機的運行順暢。
When using the frozen meat slicer, in case of the above faults, stop the machine immediately, check the relevant accessories, analyze the specific causes according to the faults, and solve them immediately to make the slicer run smoothly.
以上就是為大家介紹的有關切絲切片機的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://wwwchinafoodjxcom/
The above is the detailed introduction of the slicer. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://wwwchinafoodjxcom/

上一篇:如何選擇一臺好用的切辣椒機?
下一篇:切丁切塊機可以對哪些食材進行加工?

相關新聞